Hi guys, looking for a bit of help.I have been looking at this forum for years so I hope somebody may have an answer.
The company I work for uses mainly pulse mig for mild steel, Ali, and stainless.
We have always had problems with stainless often getting excessive spatter. We have new kempii fastmig x450 machines which seem great but often have lots spatter on stainless.I,'ve tried everything . Lots of trim and lots of inductance etc but it doesn't make alot of difference.
We use bohler 1mill wire and our stainless is 304, 308 and316.
We are using a water based anti spatter. With mild steel we get no spatter whatsoever and no anti spatter is ever needed. Any suggestions guys? Thank you.