Welcome to UKWelder Welding Caps Welding Helmets Pioner Overalls Welding Gloves
UKWelder Shop
Welding Hoods Welding Leathers Welding Helmet Spares Welding Boots

Welcome Guest ( Log In | Join the Forum )

 
Reply to this topicStart new topic
> TPS 320i to manual mode
ra2u18
post Jun 7 2019, 07:09 PM
Joined: 7-Jun 19



I have just received my Fronius TPS 320i and I am struggling to configure it to run in manual mode.

I have only 2 modes namely, intern and extern which both have the starting commands programmed for the robot. I couldn't find in the book how to deactivate the robot mode and weld manually. If you had the same experience I would love to get some insight in how to solve this problem. Thank you!
Daveyton
post Jun 14 2019, 07:06 AM
Joined: 18-Sep 13



Hi Ra2u18.

R u in UK.? If so I would give Fronius uk a call for support. You will have to take the robot interface off the back of the welding machine to start with. You will also require a manual wire feeder as I donít think the robotic feeder is compatible to use a manual torch.

Hope this helps.

Cheers
Go to the top of the page
Start new topicGo to the top of the page
Click on the Lion to return to the homepage Click on the Lion to return to the homepage