Welcome to UKWelder Welding Caps Welding Helmets Pioner Overalls Welding Gloves
UKWelder Shop
Welding Hoods Welding Leathers Welding Helmet Spares Welding Boots

Welcome Guest ( Log In | Join the Forum )

 
Reply to this topicStart new topic
> 1916s rods
fab shop cat
post Dec 5 2017, 03:48 PM
Joined: 9-Aug 08



Anybody used 1916s rods ? Is there any tip too amps, arc length,
fab shop cat
post Dec 6 2017, 08:53 AM
Joined: 9-Aug 08



Sorry itís meant to be c9mv 9016s rods
Technic Al
post Dec 6 2017, 09:37 AM
Joined: 14-Oct 03



Ive never heard of them. Can you provide more info. Manufacturer, Specifications etc etc
Captain
post Dec 7 2017, 05:04 PM
Joined: 18-Nov 03



Hi Cat,
used something similar a while back, the number rings a bell, I think it was Bohler/Fox rods.
They need a good pre-heat on the parent metal, around the 200 degree C mark.
Use electrode positive and run out a 3.2mm around the 120amp mark. Keep a close arc.
Hope this helps.

But as always go by your W.P.S. mate.
Technic Al
post Dec 7 2017, 05:48 PM
Joined: 14-Oct 03



9CrMoV.....are pretty specialised for welding P91 steel, usually in Power Stations. There will be a very well defined welding procedure to follow. The WP will give you the amps. The arc length should be short and consistent.
BIG STEROID
post Dec 15 2017, 06:32 PM
Joined: 2-Sep 11



Interesting topic,In the belfast shipyard we used 1690 electrodes,anyone any specs on them?
Go to the top of the page
Start new topicGo to the top of the page
Click on the Lion to return to the homepage Click on the Lion to return to the homepage