Welcome to UKWelder Welding Caps Welding Helmets Pioner Overalls Welding Gloves
UKWelder Shop
Welding Hoods Welding Leathers Welding Helmet Spares Welding Boots

Welcome Guest ( Log In | Join the Forum )

 
Reply to this topicStart new topic
> Threads on 10N31 collet body
abasak
post Dec 10 2016, 06:50 AM
Joined: 10-Dec 16



Hello,

Does anybody know what is the thread (both type and designation) on the 10N31 collet body, both on the side that screws into the weld torch body and the one onto which the ceramic gas nozzle screws into.

I wonder if anyone has a dimensioned drawing of the 10N31 collet body or if refers to some standard (e.g. ISO/AWS/etc).

Thanks!
Abhishek
rodofgod
post Dec 17 2016, 03:33 PM
Joined: 23-Feb 03



3/8X32" SAE
Not a standard or common available size.
tominwicken
post Dec 18 2016, 01:21 PM
Joined: 14-Jan 10



3/8"x32tpi is a standard size in the "Model Engineer" range. Any decent stockist should be able to source.
rodofgod
post Dec 19 2016, 11:32 PM
Joined: 23-Feb 03



It's not a standard size in general engineering circles, I have no idea about modeling engineering. We had to order "Special Size, HSS Hand Tap, 3/8" Size, 32 Threads per Inch, Taper" so I can only go on that. It's unlikely you would be able to walk in a shop and buy this size tap without ordering first.
mtb pete
post Dec 20 2016, 09:46 AM
Joined: 4-Nov 06



3/8 x 32tpi is UNEF (unified extra fine) and like lots of metric fine threads neither common or properly rare. Dunno what thread size the ceramic end of a 17/18/26 sized collet body is but i'm betting it'll be unified, the internet suggests both 13/32 UNS (unified special, no mention of pitch) and 7/16 x 16 UNS? Obviously gas lens bodies are different at that end and FWIW 9/20 torches are threaded 5/16 x 24 UNF

This post has been edited by mtb pete: Dec 20 2016, 09:47 AM
arceyethenoo
post Dec 20 2016, 11:35 AM
Joined: 14-Dec 07



Measured my ceramic mounts and with thread gauge and mic.
Pete is spot on, as usual.

The non standard thread is for the standard ceramic which, as Pete says, is 13/32 and is 16tpi
( This equates to a 16 tpi cut on a 10mm diameter if that's not too perverse)

Gas lens is 3/4 -16tpi UNF which is a standard UNF size.


tominwicken
post Dec 20 2016, 10:50 PM
Joined: 14-Jan 10



True its not standard but i managed to buy one without difficulty for this exact purpose. The Model engineer bit seems strange but its the range its listed in, they have to call them something i suppose.
Go to the top of the page
Start new topicGo to the top of the page
Click on the Lion to return to the homepage Click on the Lion to return to the homepage